Pressure Regulator Yutaka Crown Pressure regulator with built-in heater and flow meter for carbon dioxide FCR-50N series without flow meter Product code FCR-50N-OP

feature

• This is a large flow rate pressure regulator with heater for CO2 designed for use in airtight and neutralizing equipment for welding machines.
• This device is an excellent product with a heating capacity suitable for a flow rate of 50 liters/cubic meter. Even though the gas state in the carbon dioxide tank changes and can provide constant pressure and desired flow rate.
• It is also a safe product with a built-in thermal fuse and an inescapable temperature suppression function.

Product specifications

• Liquid: carbon dioxide
• Main side working pressure (MPa): 12.0
• Secondary side operating pressure (MPa): 0.3 or less
• Inlet connection: W22-14 cap nut (right)
• Outlet connection: Φ8.5 mm pipe joint
• Standard flow rate (liters/minute): none
• High pressure side pressure gauge: 25MPa gauge
• Inlet pressure (MPa): 12 or less
• Low pressure side pressure gauge: 1MPa gauge
• Usage flow rate (L/min):50 or less
• Mass/unit mass: 3kg

Terms of use

• When using, please plug it into the power source and turn on the heater for at least 5 minutes.
• If the rear heating cover is not hot even after 3 minutes after turning on the device There may be a problem with the electrical system.
• In this case, please check the power supply and if there is no abnormality, there may be a problem with the heater of this product. Therefore, please contact us or our sales representative.
• Please turn off the power when not in use.

note

• This product cannot be used with a siphon cylinder.